EVO 5500 | Electromem | Multifunctional Battery Charger-Starter
- Safe and efficient use
- Digital control panel.
- Potentiometer for regulating the charge current.
- Professional 12-24V copper output connections with quick coupling
- : In Stock! Estimated Delivery Time: 2-4 Days
- Brand: Electromem
- Model: EVO5500
EVO 5500
EVO 5500 is a complete and professional Multifunction instrument on wheels that is suitable for charging and starting all 12 and 24 Volt electrical systems in vehicles: cars, commercial vehicles, trucks, small, medium and large work vehicles. It is a powerful, reliable device run by a microprocessor, and it was designed to carry out automatic charge cycles specifically for standard Wet batteries and new Gel/Agm batteries with up to 10 charge and analysis phases. Thanks to the new ECS (Electronic Control System) technology, the EVO series combines excellent reliability during fast charging and maintenance with higher power for carrying out start cycles in complete safety, saving the control panels of modern vehicles. Multifunction Battery charger Starter ECS Technology.
Safe and efficient to use
- Digital control panel.
- Potentiometer for charging current adjustment.
- 12-24V professional brass quick-connect output connections.
3 Programmed charge cycles + 1 Manual cycle
The 3 programmed cycles allow clear and rapid selection of the power to be delivered by the charger according to battery capacity; the three cycles divide the batteries into three macro categories (30 Ah to 80 Ah, 80 Ah to 150 Ah and 150 Ah to 300 Ah). The manual charging cycle allows the charge to be controlled dynamically by means of an electronic potentiometer.
Potentiometer of electronic regulation of current
The EVO series digital potentiometer allows a wide linear adjustment of the charging current, from very low values (1 A) up to the maximum rated current of the charger (for batteries from 4 Ah to 550 Ah). Ideal in case you need to make quick charges or "extreme" recovery attempts.
Electronic Control System
ECS is the electronic control system that enables safe automatic start-up while preserving the on-board electronics of modern vehicles. The EVO 5500 offers high performance and is an inexhaustible source of energy.
Specific processes charging WET-SPIRAL/GEL-AGM
The EVO series battery chargers are designed to charge all types of lead-acid batteries on the market. Particular attention has been paid to the development of charging cycles for batteries with AGM technology currently in use on vehicles equipped with the START & STOP system.
SUPPLY Function
This function is particularly useful: during long phases of vehicle reprogramming it sustains the battery at a voltage of 13.5 V or 27 V also allows for constant maintenance buffer charges (phase eight) with no time limit.
Built-in electronic protection
EVO 5500 is equipped with a sophisticated system of electronic protections; it is protected against overload, short-circuit, does not cause sparks, and also activates the sound and light signal if reverse polarity is made.
WET-SPIRAL/GEL-AGM specific charging processes for 10 steps
The 10 charging stages are divided into four macro-categories:
Analysis (1-7-9), Charge (4-5-6),
Recovery (2-3), Maintenance (8-10).
- Analysis 1
- Desulfation
- Current-controlled charging
- Mass charge
- Constant voltage charge
- Recovery cycle
- Analysis 2
- Buffer maintenance
- Analysis 3
- Pulse-controlled maintenance
Full control of charging processes
The digital control panel enhances the user experience and reliability of a device designed for a demanding professional.
Supported battery types
Ideal for all types of lead-acid batteries:
Wet, Gel, Agm, Spiral, Tubular,
Mf, Vrla and Start&Stop batteries.
Supply voltage 50/60 Hz 1Ph | 230 V |
Power | 1.5-10 kW |
Output voltage | 12-24 V |
Charging current | 1 A – 50 A - Arith 75 A - Eff. |
Starting current | 400 A MAX cc |
Rechargeable batteries | PB Wet-Gel-Agm-Spiral-Tubolari-Mf-Vrla |
Charging capacity | 4-550 Ah |
Size | 380x310x950 mm |
Weight | 19.4 Kg |