92PCS Set Of Connectors And Terminals For a Multimeter | Autool

The kit includes various test terminals and connectors. They are particularly convenient to store neatly in one place and to be used by all technicians for inspection and repair work. With the help of this kit, you will be able to diagnose and test vehicle electronic control systems.

Precio:

156.20€

Cantidad

When testing various components, they can be tested directly from the back side of the wires without interrupting the electrical circuit, minimizing damage to the insulating rubber of the line as much as possible.
Ability to connect components to any measuring device. It is a good opportunity to expand the scope of oscilloscopes and it will help to reduce wiring problems.
You don't need to cut or disconnect the wire to measure the current. The component under test can be connected to the circuit in series.
An adjustable potentiometer can simulate a water temperature sensor, throttle valve, or other component. As a result, you will be able to save time searching for the problem and avoid expensive component costs.
The dual LED strobe can monitor Halo, photoelectric signal, fuel injectors, solenoid valves, automatic transmission shift solenoid valve and other drive control signals.
SRS simulated connectors that will be able to simulate airbags, seat belt buckle resistance. This will allow you to carry out inspections of these components and avoid accidents, wrong decisions during the technical inspection.
Different wire resistances can be adapted to the plug terminals of various European, United States, Asian car systems.
Add to your collection of measuring devices and turn them into powerful diagnostic devices.
Ability to test various complex electrical circuits, components and record their parameters and determine the causes of failure.
The set consists of 92 components.