CD400 Tachograph Programmer | Tachograph Calibration Tool | Truck Tacho Programmer

CD400 Tachograph Programmer. Device is designed for verification, calibration and configuration of control devices i.e. tachographs installed on vehicles. It can be used as speed simulator for a tachographduring checking the speedometer and odometer. User friendly, clear 4 lines menus, no training required. It can perform many functions like Activation and deactivation of IMS, VDO, Odometer reset and mileage corrections, speed simulations, DTCS readings, Sensor pairing and so on. CD400 The only tester being able to reset the odometer and change the sender type on the VR2400.

Multi-languages: English, Russian, Deutsch, Español, Français, Nederlands, Português, Turkish, Romanian, Serbian 

Analogs: KTCO 1314/1318, Motometer EGK100, FTCO 1319, MTCO 1324/1390, TSU 1391, VR2400.
Digitals: DTCO 1381 (DTCO® 2.1 active), SE5000 (Exakt Duo), SmarTach, EFAS-4. 

Functions

• W figure determination on measuring track (with optional photo-cell) or rolling road;
• K figure measure on KTCO 1314, KTCO 1318 and FTCO1319;
• Parameter programming;
• Activation and deactivation of IMS (Independent Motion Signal);
• Activation and deactivation of VDO counter;
• Odometer reset and adjustment (mileage correction);
• Speed simulation and customization automatic test diagram;
• DTCS reading (Digital) and erasing;
• Sensor pairing (KITAS activation);
• Clock test;
• Workshop card’s PIN recording and input through CD400 blue.